DCC OperationLightAll™ will operate like most standard NMRA decoders, but without speed control functions. The decoder can be controlled using the many of the function buttons on your DCC controller.
LightAll™ like most DCC decoders, is preset with a default address of #3. LightAll™ uses short addressing (1-127). Programming can be done on the "program track" and/or "main track". Once you have given your LightAll™ decoder an address, use the accessory function to turn on/off light, change lighting effects, change brightness/dimness, and light effect rate.
Operation
F1
Zone 1 On/Off
F0
Zone 2 On/Off
F3
Zone 3 On/Off
F4
Zone 4 On/Off
F5
Zone 5 On/Off
F6
Master Power On/Off
F7
Dim Last Controlled Light Zone
F8
Brighten Last Controlled Light Zone
Below is the CV Programming Chart for LightAll™
CV1
DESCRIPTION
RANGE
DEFAULT
Short Address
1-127
3
CV19
Advanced Consist Address
0-127
0
CV51
Zone 1 Light Effect
0-20
CV52
Zone 2 Light Effect
CV53
Zone 3 Light Effect
CV54
Zone 4 Light Effect
CV55
Zone 5 Light Effect
CV61
Zone 1 Brightness
0-200
200
CV62
Zone 2 Brightness
CV63
Zone 3 Brightness
CV64
Zone 4 Brightness
CV65
Zone 5 Brightness
CV71
Zone 1 Light Rate
0-32
15
CV72
Zone 2 Light Rate
CV73
Zone 3 Light Rate
CV74
Zone 4 Light Rate
CV75
Zone 5 Light Rate
CV125
Programming to "1" will restoresome CV's to factory settings
---
Consisting Light Genie™LightAll™ may be consisted with other LightAll™, in the same way that you would consist locomotive decoders. This will allow you to operate multiple LightAll™ as one unit; while still allowing each LightAll™ to function as independent decoder with its own address. Consisting is programmed through CV19 using addresses (0-127).