Data Sheets Pitch Settings .50 using OS 50 SX-H 30% Morgan fuel, Enya #3 glow plug, stock muffler, and box stock 570mm FRP main blades Pitch Condition Low pitch ¼ stick pitch Mid stick pitch ¾ stick pitch High end pitch Normal -11 -6.5 0 6.5 11 Stunt 1 -11 -6.5 0 6.5 11 Stunt 2 -11 -6.5 0 6.5 11 Hold -11 -6.5 0 6.5 11 Throttle Curve settings using OS 50 SX-H 30% Morgan fuel, Enya #3 glow plug, stock muffler, and box stock 570mm FRP main blades Throttle% Condition Low stick position ¼ stick position Mid stick position ¾ stick position Full stick position Normal Trim at center 19% 36% 50% 100% Stunt 1 100% 68% 46% 68% 100% Stunt 2 100% 60% 44% 60% 100% Hold N/A N/A N/A N/A N/A On 9Z and 8U radios throttle cut activated, throttle curve "LOW" set to 71%, "0" point set at 100%, Normal mode only ATV's (rudder set at 100/100) Condition Aileron Elevator Throttle Rudder Pitch (aux 1) Gyro (gear) Normal 100/100 80/80 100/100** 80/80 78/78* 100/100 Stunt 1 100/100 80/80 100/100** 60/60 78/78* 100/100 Stunt 2 100/100 80/80 100/100** 60/60 78/78* 100/100 Hold 100/100 80/80 100/100** 60/60 78/78* 100/100 On the 9Z radio, ATV for pitch is set at 100 and the high and low settings in the pitch curve screen are set to 78/78 respectively. Carburetor throttle lever pivot ball at outer postion. AFR (chart for 9Z radio only) Condition Aileron Elevator Rudder Gyro (gear) Normal 100/100 100/100 80/80 70/70 Stunt 1 100/100 100/100 60/60 60/60 Stunt 2 100/100 100/100 60/60 60/60 Hold 100/100 100/100 60/60 70/70 D/R & EXP Condition Aileron Elevator Throttle Rudder Normal -40% exp. -40% exp. N/A -20% exp. Stunt 1 -20% exp. -20% exp. N/A -20% exp. Stunt 2 -40% exp. -40% exp. N/A -20% exp. Hold -40% exp. -40% exp. N/A -20% exp. Aileron Elevator Throttle Rudder Pitch Servo horn pivot ball position 14mm 10mm 14mm 14mm 13mm Main Needle (high) Low Speed (mixture control) Glow Plug Needle Valve Settings 1 1/4 Factory Default Enya #3 Equipment Used: Sceadu OS50 SX-H, stock muffler Main Blades Stock Kit Hirobo 570mm FRP Tail Rotor Blades Stock tail blades Gyro GY601 w/ 9251 Servos 9204 Battery 1500 mah Futaba Header Tank Yes, 2 oz. T & T Paddle Set up Lead weight used only Mixing Arm Position Inner hole, input side Seesaw Position Manual suggested location Swash to throttle mix Active in stunt modes 1 & 2, 100% Gyro Gain 70% Normal & Hold, Stunts 60%